Visualizza wikitesto di Correzione dell'errore lineare con fattori di scala

== Introduction ==
In addition to the full 24 parameter volumetric compensation of the CMM, it is possible to apply <b> Scale Factores</b> to correct some residual linear error.

== Procedure ==
The factors shall be add to a figuration file as follow:
#Open the Folder <b>..\Data</b> with Windows Explorer
#Open the File <b>Machine.ini</b>
#If not present, add in the bottom of the file the following lines:
 [SFACTORS]
 SFX1=1
 SFY1=1
 SFZ1=1
 SFX2=1
 SFY2=1
 SFZ2=1
#Type, for each axis and for arm, the scale correction to be applied
#Press <b>File -> Save</b>
#Press <b>File -> Exit</b>

== Usage Warning ==
<b>THE CORRECTION OF THE LINEAR ERRORS WITH SCALE FACTOR IT IS NOT
RECOMMENDED AND IT IS PREFERABLE TO USE A FULL ERROR MAPPING.</b>

== Scale Factor Calculation ==


Scale factor= nominal length of the gauge / measured length of the block

[[it:Correzione dell'errore lineare con fattori di scala]]
[[zh-cn:具有比例因子的线性误差校正]]
[[pt:Correção de erro linear com fatores de escala]]
[[de:Korrektur des linearen Fehlers mit Skalierungsfaktoren]]
[[es:Corrección de error lineal con factores de escala]]
[[en:Correction of Linear Error With Scale Factors]