Slia: Creata pagina con "'''CNC Mode''' is the state of the CMM that allows automatic movements. The DMIS enhance two different attitudes based on the CNC Mode selected: *MODE/PROG,MAN: T..."

2018-06-01T10:03:38Z

Creata pagina con "'''CNC Mode''' is the state of the CMM that allows automatic movements. The DMIS enhance two different attitudes based on the CNC Mode selected: *MODE/PROG,MAN: T..."

Nuova pagina

'''[[CNC Mode]]''' is the state of the CMM that allows automatic movements.

The [[DMIS]] enhance two different attitudes based on the [[CNC Mode]] selected:
*MODE/PROG,MAN: The CMM is in PROGRAMMED mode, the path is determined by the commands listed in the MEAS/ENDMES block and the inspection will be performed following the PTMEAS commands.
*MODE/AUTO,PROG,MAN: The CMM is in AUTOMATIC mode, if the measuring feature has an canned cycle, then this will be performed even if the MEAS/ENDMES block contains PTMEAS commands.
The [[custom canned cycles]] (Non-[[DMIS|Dmis]] standard) enhanced by ARCO, if set, are also executed in AUTO mode.

[[it:Modalità CNC]]
[[zh-cn:CNC模式]]
[[pt:Modo CNC]]
[[de:CNC-Modus]]
[[es:Modalità CNC]]
[[en:CNC Mode]]

Modalità CNC - Cronologia

Slia: Creata pagina con "'''CNC Mode''' is the state of the CMM that allows automatic movements. The DMIS enhance two different attitudes based on the CNC Mode selected: *MODE/PROG,MAN: T..."