Modulo di controllo dell'ingranaggio

https://en.wikipedia.org/wiki/Gear#/media/File:Gear_reducer.gif

The gear package in Arco allows the measurement of Spur and Helical gears with a CMM.
The measurement can be performed with:

• Point to Point (trigger) probe
• Continuous Scanning Probe
• PH20

By input the nominal data of a gear, Arco produce a program specifics for that gear automatically.
The preview allows the user to select all the metrologycal parameter for gear inspection such us:

• Limits and number of points for of the Involute
• Limits and number of points for if the Generatrix
• Safety radius for auto probe change
• Identification of the teeth to be measured
• Height of the gear
• Type of alignment within
  • Current Reference System
  • Plane and Cylinder
  • Cylinder
  • Synchronization of the tooth only

• Gear Program Definition
• 
• 
• 

Based on the parameter ARCO creates a full program with all the points to be takes and the correct alignment procedure.
At the end of the execution is generated a PDF report that goes with the international standards, the parameters evaluated are:

• Profile Error (Fa,ffA,fHa)
• Flank Error (Fb,ffb,fHb)
• Quality Class
• Left and Right Pitch Error (fp,Fp)
• Thickness and Run-out (Ues,Aes,Les,Fr)

• Gear Report
• 
•